How to Fix a Toilet That Won’t Flush


One of the many appliances in our homes that may go out of operation is the toilet. The toilet is a vital appliance, but certain internal or external factors could make it inoperable. Thankfully, many fixes are just a few steps away to get it back to its standard operating mode.

Sometimes, you may come across a toilet that will not flush properly. This problem can be due to many reasons, but the most important step is to address the plumbing issue quickly. If you find a broken difficult to solve, it may be time to test out various fixes.

Here is a guide on how to fix a toilet that won’t flush:

Find out why a toilet won’t flush

The thing about toilets is that most are not made to flush down many objects in one flush. Rather, it will take multiple flushes if you plan on sending anything down the bowl. Some of us may just toss extra toilet paper inside, thinking that the appliance will do its job. This can be rather counterproductive in the long run.

You should also know what you are putting down into your toilet bowl, as this can affect the flush. Too much toilet paper at one time, for example, may force your appliance to work overtime. This will inevitably backfire, and it can permanently damage the toilet’s operative functions too!

Sometimes, it will take a professional to investigate the cause of why the toilet is not working. Call in a plumber if you feel like having issues diagnosing the flushing component. These plumbing services are trained in their craft, and they will eventually figure out why the toilet is not working. Whatever the case, you do not have to worry about your toilet not working for long periods again!

Use plunger to fix a toilet

One of the most traditional and most effective means of fixing a toilet is through the plunger. It is a convenient tool that works its magic through a basic function. All you need to do is push the plunger into the bowl, ensuring good suctioning is present. Then, pull the plunger back up.

The motion to get acquainted with here is to ensure you repeat the preceding actions. Always make sure the plunger has good suction on the bowl, pull up, and push down again. If excess waste prevents the toilet from flushing properly, the plunger will do its job effectively.

Check the toilet valve

In some cases, the water level of the toilet’s tank may be of some concern to you. For the most part, the amount of water inside the tank should be approximately one inch. This inch should be below the top of the tank’s overflow tube. Turn your attention to the water valve if the water is too low.

Sometimes, the water valve may have been purposefully or accidentally shut off. All it takes is a simple switch to turn it back on so that the water refills back to its normal levels. After the water has returned to the tank, the flushing functionality should have returned as well.

Use the toilet flapper

A toilet that has not been flushed properly may result from a damaged flapper. At this point, you will have to remove the toilet tank lid and inspect the rubber material. If the flapper looks like it has taken damage, it will need to be replaced. Usually, there are a ton of ways in which this can occur.

Normally, the actual repair job does not have to be challenging in the slightest. Turn off the water and drain the tank to get the toilet flushing back as normal again. Then, swap the old flapper out for a new one and try flushing the toilet again. If it has been installed correctly, the issue will have been fixed.

Use the toilet lift chain

There may be other situations where your toilet is not flushing for many reasons. If you have checked all commonly-affected areas, the next step is to inspect the lift chain. The lift chain attaches the flapper to the flushing handle outside the toilet. This part can become compromised as well.

The fix for this issue can be relatively easy as well. Simply adjust the length of the chain to shorten it so that the chain can be granted an easy pull again when the toilet flushes. At this point, the toilet should be working in its normal, functioning state once again.


log in

reset password

Back to
log in